1. The clutch must be cleaned before installation to remove rust proof grease and sundries.
2. The clutch can be installed coaxially or separately. The axial direction must be fixed. Neither the driving part nor the driven part is allowed to move axially. When installing separately, the coaxiality between the driving part and the driven part should not be greater than 0. 1mm.
3. When the wet electromagnetic clutch is working, lubricating oil must be added between friction discs, and the lubrication method is (1) separately pouring oil lubrication; (2) Oil bath lubrication, the part immersed in the oil is about 5 times the volume of the clutch; (3) The oil supply method of the shaft center shall be adopted during high-speed and high-frequency operation.
4. When installing the jaw type electromagnetic clutch, it is necessary to ensure that there is a certain clearance between the end face teeth, so that there is no grinding phenomenon when idling, but it shall not be greater than δ Value.
5. The electromagnetic clutch and brake are Class B insulation, and the normal temperature rise is 40 ℃. The working temperature at the time of limit thermal balance shall not exceed 100 ℃, otherwise the coil and friction part are easy to be damaged.
6. Power supply, control circuit and clutch power supply are DC 24V (except for special orders). It is obtained by three-phase or single-phase AC voltage through step-down and full wave rectification (or bridge rectification). Without voltage stabilization and flat wave, the power is required to be large enough. Half wave rectifier power supply is not allowed.
7. Requirements of automobile transmission system on clutch
According to the use of the clutch, it shall meet the following main requirements:
The connection is smooth and soft to ensure the smooth start of the car,
The separation is fast and complete, which is convenient for shifting and engine starting;
With appropriate reserve capacity, it can not only ensure the transmission of the maximum torque of the engine, but also prevent the overload of the drive train;
The transmission inertia of the driven part shall be as small as possible to reduce the impact during shifting;
It has good heat dissipation capacity. When the clutch needs to be operated frequently during driving, the driving and driven parts of the clutch will slip relatively, generating friction heat. If the heat does not dissipate in time, its working reliability and service life will be seriously affected;
It is easy to operate to reduce driver fatigue.




