Nov 19, 2026 Leave a message

ATV / UTV CVT Clutch Tuning: A Practical Guide To Weights And Springs

A sluggish launch, unexpected engine revs under load or recurring belt wear can point to several different problems. If the belt and clutches are in good condition, the way the CVT is calibrated may be worth reviewing, especially after a change in tire size or how the vehicle is used.

The cover shows two separate clutch examples for Polaris applications. The OEM reference numbers are 1323328 for the driven clutch and 1322971 for the drive clutch. Confirm each part number against your vehicle before ordering.

How the CVT shifts

A belt connects the primary (drive) clutch on the engine to the secondary (driven) clutch on the drivetrain. As engine speed rises, flyweights in the primary clutch move outward and help close its sheaves, pushing the belt to a larger running diameter. The secondary clutch opens as the transmission shifts to a taller ratio. When load increases, such as on a climb, backshift brings the CVT toward a lower ratio so the engine can recover RPM.

What primary clutch weights change

With the rest of the CVT setup held constant, heavier flyweights tend to promote earlier upshift and lower engine RPM while the CVT is shifting. Lighter flyweights tend to delay upshift and raise shift RPM. On adjustable designs, the position of the added mass also affects when it changes the shift response. Use the clutch or kit maker's chart to select the weight and its placement for your application.

What the springs and helix change

- Primary spring. The spring load near the start of clutch travel helps set engagement RPM. A higher initial spring load generally raises engagement RPM when the other components stay the same. Spring load farther into the travel also affects how the clutch upshifts against the flyweights.
- Secondary spring and helix. These work together to influence how the driven clutch responds to load, including how quickly it backshifts. Their effect depends on the clutch design and on the rest of the calibration.

Match the calibration to the vehicle and its work

Larger-diameter tires effectively make the gearing taller. Towing, climbing and soft terrain can also increase the load on the drivetrain. Start with the vehicle or kit maker's chart for your model, tire size, elevation and intended use. An engine that loses power at altitude may need a different calibration to hold the intended shift RPM. The appropriate change depends on the engine and clutch setup.

Check the baseline before changing parts

Inspect the belt and sheave faces and check belt deflection or belt position where the service manual specifies it. Have worn or binding clutch components addressed first. If engine RPM rises without a corresponding gain in road speed, check for belt slip and wear before attributing it to the calibration. Keep the CVT cover installed during testing and use the service manual procedures and specified tools for clutch work. Change one variable at a time and compare engagement and shift RPM under similar conditions.

Replacement parts or a calibration kit?

If the goal is to restore factory behavior, start with replacement parts that match the original application. If the goal is to adapt the CVT to a different tire size, operating elevation or workload, look for a calibration kit with guidance for that exact combination.

For help identifying a replacement drive or driven clutch, contact UCAN Industrial at ucanindustry.com with your vehicle's make, model, year and existing part number. Include tire size and intended use when asking about a calibration change.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry